Operating InstructionsConductive probe EL 8Document ID:32655Conductive
Extreme vibration caused by the system, e.g. due to agitators orturbulence in the vessel from fluidisation, can cause the probe of EL 8to vibrate in re
Fig. 3: InflowingmediumThe probe should protrude into the vessel to avoid buildup. For thatreason, avoid using high mounting bosses for screw-in fitting
5 Connecting to power supply5.1 Preparing the connectionAlways keep in mind the following safety instructions:l Connect only in the complete absence o
The EL 8 can be equipped optionally with a grounding eye. Connectthe ground cable according to the following illustration.12Fig. 4: Groundconnection (
6 Setup6.1 General informationYou can find the setup procedure for EL 8 in the operating instructionsmanual of the corresponding signal conditioning in
7 Maintenance and fault rectification7.1 MaintenanceWhen used as directed in normal operation, EL 8 is completelymaintenance free.7.2 Rectify malfuncti
l Attach the completed form and, if need be, also a safety datasheet outside on the packagingl Please ask the agency serving you for the address of yo
8 Dismounting8.1 Dismounting stepsWarning:Before dismounting, be aware of dangerous process conditions suchas e.g. pressure in the vessel, high temper
9 Supplement9.1 Technical dataGeneral dataMaterials 316Ti corresponds to 1.4571, 316L corresponds to 1.4404 or 1.4435Materials, wetted parts- Process
9.2 Dimensionsø 6,8mm(17/64")ø 4mm(5/32")ø 24mm(15/16")30mm(1 3/16")12mm(15/32")9,3mm(23/64")27mm(1 1/16")SW 27mm(1
Contents1 About this document1.1 Function. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .31.2 Target group . . . . . . . . . . . .
9.3 Industrial property rightsVEGA product lines are global protected by industrial property rights.Further information see http://www.vega.com.Only i
Conductive probe EL 8 219 Supplement32655-EN-100208
22 Conductive probe EL 89 Supplement32655-EN-100208
Conductive probe EL 8 239 Supplement32655-EN-100208
VEGA Grieshaber KGAm Hohenstein 11377761 SchiltachGermanyPhone +49 7836 50-0Fax +49 7836 50-201E-mail: [email protected] date:ISO 9
1 About this document1.1 FunctionThis operating instructions manual provides all the information youneed for mounting, connection and setup as well as
2 For your safety2.1 Authorised personnelAll operations described in this operating instructions manual must becarried out only by trained specialist
2.5 Safetyinstructions for Ex areasPlease note the Ex-specific safety information for installation andoperation in Ex areas. These safety instructions
3 Product description3.1 ConfigurationThe scope of delivery encompasses:l EL 8 point level sensorl Documentation- this operating instructions manualThe
Conductive probes detect the product resistance when their electro-des are covered by the product.The switching signal is determined by the length or
l Protected against solar radiationl Avoiding mechanical shock and vibrationl Storage and transport temperature see chapter "Supplement -Technica
4 Mounting4.1 General instructionsIn general the level switch can be mounted in any position. Theinstrument must be mounted in such a way that the pro
Kommentare zu diesen Handbüchern