Supplementary instructions manualHeating for the indicating and adjustment modulePLICSCOM
5 Connecting to voltage supply5.1 Preparing the connectionFollow the instructions in the operating instructions manual ofthe sensor.The heating must b
2 Connect the black ground cable (6) to the ground screw (5)3 Plug the green connection cables to the cable gland (4)and the green connection cables t
5.3 Plug connection4123Fig. 5: View to the plug connector with 4 … 20 mA/HART1 -(Pin 1)2 + (Pin 2)3 free (Pin 3)4 free (Pin 4)Contact pin Colour conne
6 Setup6.1 SetupThe setup is carried out according to the operating instructionsmanual of the respective sensor.The heating is permanently available a
7 Maintain7.1 Instrument repairIf it is necessary to repair the instrument please proceed asfollows:You can download a return form (23 KB) in the Inte
8 Dismounting8.1 Dismounting procedureTake note of chapters "Mounting" and "Connecting to powersupply" and carry out the listed st
9 Supplement9.1 Technical dataTechnical dataAll technical data are listed in the operating instructions manual of the respective sensor.General dataMa
9.2 DimensionsHousing versions - instrument housingø77mm (3 1/32")112mm (4 13/32")69mm (2 23/32")ø77mm (3 1/32")69mm (2 23/32"
18 Heating for the indicating and adjustment module PLICSCOMSupplement31708-EN-061219
Heating for the indicating and adjustment module PLICSCOM 19Supplement31708-EN-061219
Contents1 About this document1.1 Function ...31.2 Target group ...31.3 Symbolism used ...
VEGA Grieshaber KGAm Hohenstein 11377761 SchiltachGermanyPhone +49 7836 50-0Fax +49 7836 50-201E-mail: [email protected] 9001All stateme
1 About this document1.1 FunctionThis supplementary manual, together with the attachedoperating instructions manual, has all the information you needf
2 For your safety2.1 Authorised personnelAll operations described in this operating instructions manualmust be carried out only by trained specialist
3 Product description3.1 ConfigurationIf the sensor is already ordered with a heating, then the heatingis already mounted.However, the heating can be m
3.3 Storage and transportYour instrument was protected by packaging during transport.Its capacity to handle normal loads during transport is assuredby
4 Mounting4.1 Mounting preparationsThe following tools are required for mounting:l Flat wrench SW 24l Slotted screwdriver 3 mm4.2 Dismounting the elec
213Fig. 2: Mounting the thermostat1 Thermostat2 Cable gland3 Electronics moduleProceed as follows:1 Plug the thermostat to the oscillator2 Remove the
3 Connect the connection cables according to the operatinginstructions manual of the respective sensorHeating for the indicating and adjustment module
Kommentare zu diesen Handbüchern