RMT-10 VHFRack-Mount TransmitterInstruction Manual099-0068D
RF NoiseProblems with RF noise sources (fluorescent lights, car ignitions, industrialequipment, etc.) are quite rare. Defective fluorescent lighting f
SpecificationsProduct Description: VHF audio transmitterFrequency Control: Single frequency, crystal controlledFrequency Stability:±0.005%Operating Fr
Quick StartPlease see Figure 1 and the instructions on the next page for a quick start.A Word to Vega UsersIn selecting Vega equipment, you are in the
Transmitter 35. Put on rack-mount (1a) “ears” or (1b) rubber feet (for details see “Installation”next page).6. Attach the whip antenna (see the “Whip
IntroductionThis document describes setup, adjustment, and operation only; detailedmaintenance information is not included. If you have any questions,
InstallationThe RMT-10 can be mounted in a standard 19-inch (48-cm) rack, or operate standingalone. For stand-alone operation: Peel off the four rubbe
Whip Antenna LengthFor optimum antenna efficiency, the wire whip may be cut to length. Do NOT try to cutthe whip with wire cutters, the whip is made f
Power supply negative (–) to the outer conductorPower supply positive (+) to the inner conductorAdjustmentsNote: Normal setup and operation does not r
For use with Clearcom or RTS intercoms, or for 70-volt line applications, use thesame basic adjustment procedures as above.Frequency-Compensation Adju
AntennasProper mounting and placement of antenna(s) is vitally important in wireless systems.If overlooked, antennas might cause unnecessary problems.
Kommentare zu diesen Handbüchern