Vega PLICSAKKU for VEGAPULS Safety instructions Bedienungsanleitung PDF herunterladen (Seite 4)

2 Possible dangers and their causes

The accumulator pack consists of individual hermetically sealed

containers which are designed to withstand normal temperatures and

pressures when used correctly. Under these conditions there is neither

a ﬁre/explosion hazard nor a danger of leaking contents. Incorrect

handling can cause overheating, ignition, deﬂagration or explosion.

Should this happen, toxic gases can be released and persons injured

through acid burns and poisoning.

The following factors could cause ﬁre and explosion damage:

l Mechanical damage

l Short-circuit/wrong polarity on the connections leading to the

outside

l Excessive current drain due to incorrect use

l Too high temperatures (see technical data)

l Contact of the accumulator contents with water

l Charging the accumulator pack with a non-approved battery

charger

Caution:

In the case of strong mechanical impact or a high-impact event to the

test system or the accumulator pack (e.g. drop from heights/accident)

the safety of the pack is no longer guaranteed. The accumulator pack

may look ﬁne but there can be a perforation or damaged wire.

To avoid ﬁre damage through self-ignition due to mechanical eﬀects or

an impact, the battery pack must be monitored for at least one hour at

a ﬁreproof, well ventilated place. To avoid the risk of undetected

damage to the battery pack, we recommend disposing of the battery

pack according to the valid regulations.

Interrupt the charging process if the accumulator cannot be charged

within the speciﬁed charging time of approx. four hours. Otherwise the

battery can overheat, get cracks or ignite.

4 PLICSAKKU • Lithium-Polymer accumulator pack for VEGAPULS

2 Possible dangers and their causes

41932-EN-120416

1 2 3 4 5 6 7 8 9 ... 19 20

Keine Kommentare

Vega PLICSAKKU for VEGAPULS Safety instructions Bedienungsanleitung Seite 4