Vega TH LINK Version 1.1 Installation Guide Bedienungsanleitung PDF herunterladen (Seite 32)

Troubleshooting

Trebing & Himstedt Prozeßautomation GmbH & Co. KG | TH LINK

Troubleshooting

– Check the power supply (LED RUN must light green).

– Check for correct connection (RJ-45, see "Connecting to

Ethernet" on page 15).

– The TH LINK is preset to network operation with a DHCP

server (IP address for the TH

LINK is assigned by the DHCP

server). If your network server does not support DHCP, you

need to set the IP address for the TH

LINK yourself

(see "Connection in a network with manual IP address

assignment" on page 22).

– When a crossover cable is used between PC/notebook and

LINK, both devices must be in the same subnet.

TH LINK as Passive PROFIBUS station:

– Check for proper connection (see "Connecting the

PROFIBUS" on page 28) and switch at Settings >

TH SCOPE > Measurement the baud rate on Automatic

detection.

TH LINK as Active/Passive PROFIBUS station:

– Check the PROFIBUS parameters for the used TH LINK (see

application software, not included in the scope of delivery).

Each station has its own station address, which can only be

assigned once in the network.

TH LINK is not found in the Ethernet network

PROFIBUS network is not found

1 2 ... 27 28 29 30 31 32 33 34 35 36

Keine Kommentare

Vega TH LINK Version 1.1 Installation Guide Bedienungsanleitung Seite 32