Vega FIBERTRAC 31 Profibus PA Bedienungsanleitung PDF herunterladen (Seite 47)

6 Set up with the display and adjustment module

FIBERTRAC 31 • Probus PA

43833-EN-131119

Display: Settings, for example language, measured value display

Diagnosis: Information, for example, of device status, peak value,

simulation

Additional adjustments: Instrument unit, reset, date/time, copying

function

Info: Instrument name, hardware and software version, date of manu-

facture, instrument features

Check if the correct language is already set for the display. If not, you

can change the language in the menu item "Display/Language".

Start with the setup of FIBERTRAC 31.

In the main menu point "Setup", the individual submenu points

should be selected one after the other and provided with the correct

parameters to ensure optimum adjustment of the measurement. The

procedure is described in the following.

Stick with the normal sequence of the menu items as closely as pos-

sible.

Setup

An address must be assigned to each Probus PA instrument. Each

address may only be assigned once in the Probus PA network. The

sensor is only recognized by the control system if the address is set

correctly.

When the instrument is shipped, address 126 is adjusted. This ad-

dress can be used for function test of the instrument and for con-

nection to a Probus PA network. Then address must be changed to

integrate additional instruments.

The address setting is carried out either via:

•

The address selection switch in the electronics compartment of

the instrument (address setting via hardware)

•

The display and adjustment module (address setting via software)

•

PACTware/DTM (address setting via software)

The hardware addressing is eective if an address <126 is set with

the address selection switches on the electronics module of FIB-

ERTRAC 31. Software addressing thus has no eect - only the set

hardware address applies.

The software addressing is only eective if address 126 or higher is

adjusted on the instrument with the address selection switches.

Procedure

Setup - Sensor address

Hardware addressing

Software addressing

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare

Vega FIBERTRAC 31 Profibus PA Bedienungsanleitung Seite 47

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Vega FIBERTRAC 31 Profibus PA