Vega KV 31 Mounting brackets For tubes with ø 50…200 mm Bedienungsanleitung PDF herunterladen (Seite 5)

2 Mounting

Take note of the operating instructions of the corresponding sensor

MINITRAC and the source holder VEGASOURCE.

Take note of the following mounting instructions:

l Mount the bracket ﬁrst, then the sensor and the source holder

l The arrow cutout in the clamp (source container side) and the

transport lug of the source container must point in the same

direction (A) after mounting

l Make sure that the two clamps (5 and 8) of the bracket are in

parallel. Do this by measuring the distances between the clamps

l To avoid injuries, shorten the threaded rods (1) of the brackets to a

suitable length after mounting

Mount the bracket according to the following assembly drawing:

7 6 8

3 1 4 2

5 A

Fig. 3: Mounting bracket with horizontally mounted sensor

1 Threaded rod M10 x 360 mm - 4 pieces

2 Hexagon nut M16 - 4 pcs.

3 Hexagon nut M10 - 16 pcs.

4 Washer for M16 - 4 pieces

5 Clamp - Source holder side (VEGASOURCE 31) - 1 piece

6 Washer for M10 - 8 pieces

7 Hexagon screw M8 - 2 pieces

8 Clamp - Sensor side (MINITRAC) - 1 piece

A Arrow cutout of the clamp and the lug point in the same direction

Operating instructions

Mounting brackets for

horizontal mounting

Horizontal sensor

mounting

Mounting brackets KV 31 • Source holder SE 5

2 Mounting

38481-EN-120228

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Vega KV 31 Mounting brackets For tubes with ø 50…200 mm Bedienungsanleitung Seite 5