Vega PROTRAC series 30 Electronics module Bedienungsanleitung PDF herunterladen (Seite 16)

4 Mounting

Electronics module • PROTRAC series 30

40104-EN-130916

22. Use the edge of the plastic spatula (11) to skim the surface of the

opticalpad(4)sothatonlyawafer-thingreaselmremains.See

the following illustration.

Fig. 14: Skim the second side of the optical pad with the plastic spatula

11 Plastic spatula

23. Insert the new electronics module (2) carefully into the instrument

housing (5)

Take note of the correct direction when inserting the electronics

module. The electronics module cannot be inserted the wrong

way. Keep the plugs on the lower side in mind.

Note:

If the optical pad (4) drops out when inserting the electronics module,

you have to clean the optical pad (4) carefully, grease it again, remove

thegrease(onlyathinlmshouldremain)andplaceitagainontothe

photomultiplier (8).

24. Press the electronics module (2) carefully down onto the plug

connections.

25. Tighten the four holding screws (7)

26. Plug the already connected terminal blocks (6) carefully onto the

new electronics module (2).

Note:

The terminal blocks are uniquely coded according to the electronics

version.

Ifoneoftheterminalblocksdoesnottontotheelectronicsmodule,

check if you are using the right electronics module.

If the electronics module is correct, check the coding.

See chapter "Mounting preparations".

27. Screw the housing cover onto the housing up to the stop and pro-

tect it against unintentional opening by screwing out the hexagon

screw.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Vega PROTRAC series 30 Electronics module Bedienungsanleitung Seite 16