Fig. 3: Loosen the plug
insert
1 Cable gland
2 Plug insert
3 Plug housing
4 Remove approx. 5 cm of the cable mantle, strip approx. 1 cm
insulation from the individual wires
5 Lead the cable through the cable gland into the plug housing
6 Connect the wire ends to the screw terminals according to the
wiring plan
Fig. 4: Connection to the
screw terminals
1 Cable gland
2 Plug housing
3 Plug insert
4 Plug seal
7 Snap the plug insert into the plug housing and insert the sensor
seal
8 Plug the plug insert with seal to VEGABAR 17 and tighten the
screw
The electrical connection is finished.
Proceed as follows:
Connection via angle
plug connector with hin-
ged cover
14 VEGABAR 17
5 Connecting to power supply
27636-EN-120531
Kommentare zu diesen Handbüchern