Vega VEGABAR 81 Save sensor - Quick setup guide Bedienungsanleitung PDF herunterladen (Seite 11)

5 Set up with the display and adjustment module

VEGABAR 81 • Slave sensor for electronic dierential pressure

46331-EN-131125

5 Set up with the display and adjustment

module

5.1 Parameter adjustment - Quick setup

To quickly and easily adapt the sensor to the application, select

the menu item "Quick setup" in the start graphic on the display and

adjustment module.

Carry out the following steps in the sequence specied below. The

presettings apply to all applications.

You can nd "Extendedadjustment" in the next sub-chapter.

1. Measurement loop name

In the rst menu item you assign a suitable measurement loop name.

Permitted are names with max. 19 characters.

2. Application

In this menu item you activate/deactivate the slave sensor for elec-

tronic dierential pressure and select the application.

Note:

It is absolutely necessary to activate the slave sensor in advance to

have the applications displayed in the electronic dierential pressure

measurement menus.

3. Units

In this menu item you determine the adjustment and temperature

units of the instrument. Depending on the selected application in the

menu item "Application", dierent adjustment units are available.

4. Unit, static pressure

In this menu item, you determine the unit of the static, i.e. superim-

posed pressure.

5. Position correction

In this menu item you compensate the inuence of the installation

position of the instrument (oset) on the measured value.

6. Min. adjustment

In this menu item you carry out the min. adjustment for level.

Enter the percentage value and the corresponding pressure value for

the min. level.

7. Max. adjustment

In this menu item you carry out the max. adjustment for level.

Presettings

Quick setup - Level meas-

urement

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Keine Kommentare

Vega VEGABAR 81 Save sensor - Quick setup guide Bedienungsanleitung Seite 11