Vega VEGAPULS 66 (≥ 2.0.0 - ≥ 4.0.0) standpipe ver. Mod Bedienungsanleitung Seite 2

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 68
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 1
2
Quick start
VEGAPULS 66 standpipe version • Modbus and Levelmaster protocol
41367-EN-121011
Quick start
The quick start enables a quick setup with many applications. You
can nd further information in the respective chapters of the operating
instructions manual.
1. In case of turbulences or strong product movement in the vessel,
long standpipe antennas should be fastened to the vessel wall.
2. The measurement is only possible inside the tube, the standpipe
antenna must hence reach up to the requested min. level
For further information see chapter "Mounting".
1. Make sure that the power supply corresponds to the specica-
tions on the type label.
2. Connect the instrument according to the following illustration
+
+
power supply
MODBUS
D0
D1
IS GND
USB
1
2
1345
2off
on
( )
(
)
(-)
(-)
Fig. 1: Connection compartment
1 USB connection
2 Slideswitchforintegratedterminationresistor(120Ω)
For further information see chapter "Connecting to power supply".
The instrument is preset by default with the suitable parameters for
"Application", "Min. adjustment" and "Max. adjustment".
For adaptation of the parameter "Medium" you have to proceed as
follows:
1. Go via the indicating and adjustment module to the menu "Setup".
2. In the menu item "Medium"you select the medium of your applica-
tion, for example "Solvent".
1. In the menu "Additional settings", menu item "Damping" you have
to adjust the requested damping of the output signal.
2. Select the output characteristics in the menu item "Current out-
put".
The quick start is then nished. For further information see chapter
"Parameter adjustment".
Mounting
Connect electrically
Set parameters
Further steps
Seitenansicht 1
1 2 3 4 5 6 7 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare