Vega PLICSCOM Bedienungsanleitung PDF herunterladen (Seite 36)

6 Setup - radar sensors from software 4.0.0

PLICSCOM •

36433-EN-130228

5. Set the requested numerical value with [+] and [->]

6. Push [OK]

Note:

Duringsimulation,thesimulatedvalueisoutputtedasProbusPA 

signal.

How to interrupt the simulation:

→

Push [ESC]

Information:

The simulation is automatically terminated 10 minutes after the last

press of a key.

Inthismenuitem,youdenetheunitoftheSecondaryValues2

(SV2):

Inthismenuitem,thesensoraddressisadjustedonProbusPA.

AnaddressmustbeassignedtoeachProbusPAinstrument.The

approved addresses are between 0 and 126. Each address must

onlybeassignedonceintheProbusPAnetwork.Thesensorisonly

recognizedbythecontrolsystemiftheaddressissetcorrectly.

When the instrument is shipped, address 126 is adjusted. This ad-

dress can be used for function test of the instrument and for con-

nectiontoaProbusPAnetwork.Thenaddressmustbechangedto

integrate additional instruments.

The address setting is carried out either via:

•

The address selection switch in the electronics compartment of

the instrument (address setting via hardware)

•

The display and adjustment module (address setting via software)

•

PACTware/DTM (address setting via software)

Note:

The software addressing is only possible if address 126 or higher is

adjusted on the instrument with the address selection switches.

Additional adjustments/

Unit SV2

Additional adjustments/

Sensor address

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Keine Kommentare

Vega PLICSCOM Bedienungsanleitung Seite 36