For mounting, proceed
as follows:
1 Position VEGABAR 61 with tube isolating diaphragm
2 Tighten the threaded fittings step-by-step once on the right and on
the left
3 Hold VEGABAR 61, to avoid distortion from the defined installation
position.
Caution:
Apart from
mounting, the tube isolating diaphragm must not be
permanently under torsion.
4 Check current after mounting. The current must be between 3.9
and 4.1 mA. In case of a deviating value, losen threaded fitting and
mount again.
Information:
By slight
ly increasing or reducing the torque, the current can be set
exactly to 20 mA.
4.4 Mounting steps external housing
1 Mark the holes according to the following drilling template
2 Depending on the mounting surface, fasten the wall mounting
plate with 4 screws
Wall mounting
VEGABAR 61 • Foundation Fieldbu
s 15
4 Mounting
28258-EN-081209
Kommentare zu diesen Handbüchern