Vega VEGAPULS 61 (≥ 2.0.0 - ≤ 3.8) 4 … 20 mA__HART two- Bedienungsanleitung PDF herunterladen (Seite 52)

If there is no electronics module available on site, one can

be ordered

from the VEGA agency serving you.

The new electronics module must be loaded with the settings of the

sensor. These are the options:

l At the factory by VEGA

l Or on site by the user

In both cases, the sensor serial number is needed. The serial numbers

are stated on the type label of the instrument, inside the housing or on

the delivery note.

Information:

When loadin

g on site, ﬁrst of all the order data must be downloaded

from the Internet (see operating instructions manual "Oscillator").

The electronics modules are adapted to the respective sensor and

distinguish also in the signal output or power supply.

8.4 Software update

The software version of VEGAPULS 61 can be determined as follows:

l on the type label of the electronics

l via the indicating and adjustment module

l via PACTware

You can view all software histories on our website

www.vega.com.

Make u

se of this advantage a nd get registered for update information

via e-mail.

The following components are required to update the sensor software:

l Sensor

l Voltage supply

l VEGACONNECT

l PC with PACTware

l Current sensor software as ﬁle

At "

www.vega.com/downloads" go

to "Software". Select under "plics

instruments and sensors" the suitable instrument series. Load the zip

ﬁle via the right mouse key with "Save target as" e.g. on the desktop of

your PC. Extract all ﬁles available in the zip ﬁle, e.g. to the desktop.

Connect the sensor to power supply and provide connection from PC

to the instrument via VEGACONNECT. Start PACTware and provide

connection to the sensor, e.g. via the VEGA project assistant. Close

the parameter window of the sensor, as far as open.

Go in the PACTware menu bar to "Instrument data", "Additional

functions" and "Update instrument software".

PACTware now checks the actual hardware and software version of

the sensor and displays the data. This procedure lasts approx. 60 s.

Sensor serial number

Assignment

Load sensor software to

Prepare update

Load software into sen-

sor

52 VEGAPULS 61 • 4 … 20 mA/HAR

T two-wire

8 Maintenance and fault rectiﬁcati

28434-EN-100426

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Vega VEGAPULS 61 (≥ 2.0.0 - ≤ 3.8) 4 … 20 mA__HART two- Bedienungsanleitung Seite 52

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Vega VEGAPULS 61 (≥ 2.0.0 - ≤ 3.8) 4 … 20 mA__HART two-