Vega MoRoS GPRS 1.3 Bedienungsanleitung PDF herunterladen (Seite 22)

Mounting MoRoS GPRS 1.3

9 Mounting

This chapter describes how to mount the MoRoS GPRS 1.3 to a DIN rail, connect it to

the power supply and disassemble it again.

Danger!

Exposed electrical components!

Risk of death through electric shock hazard!

Prior to the installation, switch the power of the cabinet

off and secure it against being switched on again.

Danger!

Moisture und liquids from the environment may seep

into the interior of the MoRoS GPRS 1.3.

Risk of death through shock hazard when touching it!

The MoRoS GPRS 1.3 may not be used in wet or damp

environments, or in or very close to water. Install the de-

vice at a dry location, protected from water spray. Switch

the power supply off before you do any work on a device

which may have been in contact with moisture.

Note

The device could be destroyed if the wrong power supply

is used.

If the MoRoS GPRS 1.3 is used with a power supply which

has a larger voltage than the allowed operational volt-

age of the MoRoS GPRS 1.3, the device is destroyed.

Make sure that you use the suitable power supply. The

chapter "Technical Data" has the information about the

correct voltage range for the MoRoS GPRS 1.3.

Mount the device to the DIN rail

Instructions on how to mount the MoRoS GPRS 1.3 to a DIN rail:

1. Position the device at the DIN rail as seen in the following diagram. There

are two snap-in hooks at the outer edge of the DIN rail groove of the MoRoS

GPRS 1.3.

Hook them into place behind the upper edge of the DIN rail when connecting

the device.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 81 82

Keine Kommentare

Vega MoRoS GPRS 1.3 Bedienungsanleitung Seite 22