Vega VEGABAR 66 Foundation Fieldbus Bedienungsanleitung PDF herunterladen (Seite 13)

4 Mounting

VEGABAR 66 • Foundation Fieldbus

36740-EN-130321

4 Mounting

4.1 General instructions

Make sure that all parts of the instrument coming in direct contact

with the process, especially the sensor element, process seal and

processtting,aresuitablefortheexistingprocessconditions,such

as process pressure, process temperature as well as the chemical

properties of the medium.

Youcanndthespecicationsinchapter"Technical data"andonthe

nameplate.

Select an installation position you can easily reach for mounting and

connectingaswellaslaterretrottingofadisplayandadjustment

module. The housing can be rotated by 330° without the use of any

tools. You can also install the display and adjustment module in four

dierentpositions(eachdisplacedby90°).

Usetherecommendedcables(seechapter"Connecting to power

supply

")andtightenthecablegland.

You can give your instrument additional protection against moisture

penetration by leading the connection cable downward in front of the

cableentry.Rainandcondensationwatercanthusdraino.Thisap-

plies mainly to outdoor mounting as well as installation in areas where

high humidity is expected (e.g. through cleaning processes) or on

cooled or heated vessels.

Fig. 3: Measures against moisture penetration

The ventilation of the electronics housing as well as the atmospheric

pressurecompensationforthemeasuringcellarerealisedviaalter

element in the area of the cable gland.

Suitability for the process

conditions

Installation position

Moisture

entilation and pressure

compensation

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Keine Kommentare

Vega VEGABAR 66 Foundation Fieldbus Bedienungsanleitung Seite 13