Vega PLICSCOM Heating for the indicating and adjustment Bedienungsanleitung Seite 1

Supplementary instructions manualHeating for the indicating and adjustment modulePLICSCOM

5 Connecting to voltage supply5.1 Preparing the connectionFollow the instructions in the operating instructions manual ofthe sensor.The heating must b

2 Connect the black ground cable (6) to the ground screw (5)3 Plug the green connection cables to the cable gland (4)and the green connection cables t

5.3 Plug connection4123Fig. 5: View to the plug connector with 4 … 20 mA/HART1 -(Pin 1)2 + (Pin 2)3 free (Pin 3)4 free (Pin 4)Contact pin Colour conne

6 Setup6.1 SetupThe setup is carried out according to the operating instructionsmanual of the respective sensor.The heating is permanently available a

7 Maintain7.1 Instrument repairIf it is necessary to repair the instrument please proceed asfollows:You can download a return form (23 KB) in the Inte

8 Dismounting8.1 Dismounting procedureTake note of chapters "Mounting" and "Connecting to powersupply" and carry out the listed st

9 Supplement9.1 Technical dataTechnical dataAll technical data are listed in the operating instructions manual of the respective sensor.General dataMa

9.2 DimensionsHousing versions - instrument housingø77mm (3 1/32")112mm (4 13/32")69mm (2 23/32")ø77mm (3 1/32")69mm (2 23/32"

18 Heating for the indicating and adjustment module PLICSCOMSupplement31708-EN-061219

Heating for the indicating and adjustment module PLICSCOM 19Supplement31708-EN-061219

Contents1 About this document1.1 Function ...31.2 Target group ...31.3 Symbolism used ...

VEGA Grieshaber KGAm Hohenstein 11377761 SchiltachGermanyPhone +49 7836 50-0Fax +49 7836 50-201E-mail: [email protected] 9001All stateme

1 About this document1.1 FunctionThis supplementary manual, together with the attachedoperating instructions manual, has all the information you needf

2 For your safety2.1 Authorised personnelAll operations described in this operating instructions manualmust be carried out only by trained specialist

3 Product description3.1 ConfigurationIf the sensor is already ordered with a heating, then the heatingis already mounted.However, the heating can be m

3.3 Storage and transportYour instrument was protected by packaging during transport.Its capacity to handle normal loads during transport is assuredby

4 Mounting4.1 Mounting preparationsThe following tools are required for mounting:l Flat wrench SW 24l Slotted screwdriver 3 mm4.2 Dismounting the elec

213Fig. 2: Mounting the thermostat1 Thermostat2 Cable gland3 Electronics moduleProceed as follows:1 Plug the thermostat to the oscillator2 Remove the

3 Connect the connection cables according to the operatinginstructions manual of the respective sensorHeating for the indicating and adjustment module