37
6 Set up with the display and adjustment module PLICSCOM
VEGABAR 66 • 4 … 20 mA/HART - climate compensated
36738-EN-130321
Inthemenuitems"zero"and"span"youdeterminethespanofthe
sensor, the span corresponds to the end value.
Information:
The steps 1, 3 and 4 are not necessary for instruments which are
alreadypresetaccordingtocustomerspecications!
Youcanndthedataonthetypelabelontheinstrumentorinthe
menuitemsofthezero/spanadjustment.
The display and adjustment module enables the adjustment without
llingorpressure.Thankstothis,youcancarryoutyoursettings
already in the workshop without the instrument having to be installed.
The actual measured value is displayed in addition to the menu items
forzero/spanadjustment.
VEGABAR66ispresettoapplication"Levelmeasurement".Proceed
asfollowswhenswitchingovertoapplication"Processpressure
measurement":
1. Push the [OK] button in the measured value display, the menu
overview is displayed.
2. Selectthemenu"Service"with[->]andconrmwith[OK].
Basic adjustment
Display
Diagnostics
▶
Service
Info
3. Selectthemenuitem"Application"with[->] and edit with [OK].
Warning:
Notethewarning:"Output can change".
4. Select with [->]"OK"andconrmwith[OK].
5. Select"Process pressure"fromthelistandconrmwith[OK].
In this menu item you select the adjustment unit as well as the unit for
the temperature indication in the display.
To select the adjustment unit (in the example switching over from bar
to mbar), proceed as follows:
5)
1. Push the [OK] button in the measured value display, the menu
overview is displayed.
▶
Basic adjustment
Display
Diagnostics
Service
Info
2. Conrmthemenu"Basic adjustment"with[OK], the menu item
"Unit"willbedisplayed.
Select application "Pro-
cess pressure measure-
ment"
Select unit
5)
Selection options: mbar, bar, psi, Pa, kPa, MPa, inHg, mmHg, inH
2
O,
mmH
2
O.
Kommentare zu diesen Handbüchern