Vega FIBERTRAC 31 4 … 20 mA_HART - four-wire With SIL q Bedienungsanleitung PDF herunterladen (Seite 60)

7 Set up with the display and adjustment module

FIBERTRAC 31 • 4 … 20 mA/HART - four-wire

43386-EN-131119

If the measured value is outputted via the 4 … 20 mA output, you

must not switch over to HART Multidrop.

Themode'Standard',withxedaddress0(factorysetting),means

output of the measured value as 8/16 mA signal.

This parameter is described in the operating instructions manual

"Display and adjustment module".

With this function

•

Load parameter adjustment data from the sensor into the display

and adjustment module

•

Write parameter adjustment data from the display and adjustment

module into the sensor

This parameter is described in the operating instructions manual

"Display and adjustment module".

Info

Inthismenuyouwillndthefollowingmenuitems:

•

Instrument name - shows instrument name and serial number

•

Instrument version - shows hardware and software version of the

instrument

•

Date of manufacture - shows calibration date and the date of the

last change

•

Instrument features - shows further instrument features

These parameters are described in the operating instructions manual

"Display and adjustment module".

7.6 Saving the parameter adjustment data

We recommended noting the adjusted data, e.g. in this operating

instructions manual, and archiving them afterwards. They are thus

available for multiple use or service purposes.

If the instrument is equipped with a display and adjustment module,

the data in the sensor can be saved in the display and adjustment

module. The procedure is described in the operating instructions

manual "Display and adjustment module" in the menu item "Copy

sensor data". The data remain there permanently even if the sensor

power supply fails.

The following data or settings for adjustment of the display and ad-

justment module are saved:

•

All data of the menu "Setup" and "Display"

•

In the menu "Additional adjustments" the items "Sensor-specic

units, temperature unit and linearization"

•

The values of the user programmable linearization curve

The function can also be used to transfer settings from one instru-

ment to another instrument of the same type. If it is necessary to

exchange a sensor, the display and adjustment module is inserted

into the replacement instrument and the data are likewise written into

the sensor via the menu item "Copy sensor data".

Additional adjustments -

Copy instrument settings

Info

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare

Vega FIBERTRAC 31 4 … 20 mA_HART - four-wire With SIL q Bedienungsanleitung Seite 60

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Vega FIBERTRAC 31 4 … 20 mA_HART - four-wire With SIL q