Vega PLICSRADIO R61 Wireless receiving unit Bedienungsanleitung PDF herunterladen (Seite 16)

5 Connecting to power supply

PLICSRADIO R61 • Wireless receiving unit (single channel)

32625-EN-130228

4. Loosen compression nut of the cable entry

5. Remove approx. 10 cm (4 in) of the cable mantle, strip approx.

1 cm (0.4 in) of insulation from the ends of the individual wires

6. Insert the cable into the sensor through the cable entry

7. Lift the opening levers of the terminals with a screwdriver (see

following illustration)

8. Insert the wire ends into the open terminals according to the wir-

ing plan

Fig. 8: Connection steps 6 and 7 (connect voltage supply)

9. Press down the opening levers of the terminals, you will hear the

terminal spring closing

10. Check the hold of the wires in the terminals by lightly pulling on

them

11. Tighten the compression nut of the cable entry. The seal ring must

completely encircle the cable

12. Insert and screw terminal cover

13. If a display and adjustment module is installed, insert it by turning

it slightly to the right.

14. Screw the housing cover back on

Theelectricalconnectionishencenished.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Keine Kommentare

Vega PLICSRADIO R61 Wireless receiving unit Bedienungsanleitung Seite 16