23
5 Connecting to power supply
VEGABAR 81 • 4 … 20 mA/HART
45018-EN-131010
Fig. 16: Connection steps 5 and 6 - Double chamber housing
6. Insert the wire ends into the terminals according to the wiring plan
Information:
Solidcoresaswellasexiblecoreswithwireendsleevesareinsert-
eddirectlyintotheterminalopenings.Incaseofexiblecoreswithout
end sleeves, press the terminal from above with a small screwdriver;
the terminal opening is freed. When the screwdriver is released, the
terminal closes again.
Youcanndfurtherinformationonthemax.wirecross-sectionunder
"Technical data/Electromechanical data"
7. Check the hold of the wires in the terminals by lightly pulling on
them
8. Connect the screen to the internal ground terminal, connect the
outer ground terminal to potential equalisation
9. Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
10. Reinsert the display and adjustment module, if one was installed
11. Screw the housing cover back on
Theelectricalconnectionishencenished.
5.3 Single chamber housing
The following illustration applies to the non-Ex, Ex-ia, Ex-d vand Ex-
d-ia version.
Kommentare zu diesen Handbüchern