Vega VEGABAR 81 HART and accumulator pack - Operating I Bedienungsanleitung PDF herunterladen (Seite 37)

6 Set up with the display and adjustment module

VEGABAR 81 • HART and accumulator pack

45026-EN-131107

In the mode "Fixed current output" up to 63 sensors can be operated

on one two-wire cable (Multidrop operation). An address between 0

and 63 must be assigned to each sensor.

If you select the function "Analogue current output" and also enter

an address number, you can output a 4 … 20 mA signal in Multidrop

mode.

With the mode "Fixed current (4 mA)"axed4mAsignalisoutputted

independently of the actual level.

The default setting is "Analogue current output" and the address 00.

In this menu item, you read out the instrument name and the instru-

ment serial number:

In this menu item, the hardware and software version of the sensor is

displayed.

In this menu item, the date of factory calibration of the sensor as well

as the date of the last change of sensor parameters are displayed via

the display and adjustment module or via the PC.

In this menu item, the features of the sensor such as approval, pro-

cesstting,seal,measuringrange,electronics,housingandothers

are displayed.

6.5 Saving the parameter adjustment data

We recommended noting the adjusted data, e.g. in this operating

instructions manual, and archiving them afterwards. They are thus

available for multiple use or service purposes.

Info - Instrument name

Info - Instrument version

Info - Factory calibration

date

Info - Sensor character-

istics

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 67 68

Keine Kommentare

Vega VEGABAR 81 HART and accumulator pack - Operating I Bedienungsanleitung Seite 37