Vega LUCOM EDGE router ER75i v2 SL USER’S GUIDE Bedienungsanleitung PDF herunterladen (Seite 46)

100

101

CONFIGURATION

If parameter Backup SIM card is set to none, then parameters Switch to other SIM

card when connection fails, Switch to backup SIM card when roaming is detected and Switch

to backup SIM card when data limit is exceeded switch the router to off-line mode.

If PPP connection fails, then the parameter Switch to other SIM card when connection

fails ensures switch to secondary SIM card or secondary APN of the SIM card. Failure of the

PPP connection can occur in two ways. When I start the router, when three fails to establish

a PPP connection. Or if it is checked Check the PPP connection, and is indicated by the loss

of a PPP connection.

In case that the roaming is detected the parameter Switch to backup SIM card

when roaming is detected enables switching to secondary SIM card or secondary APN

of the SIM card.

Parameter Switch to backup SIM card when data limit is exceeded enables switching

to secondary SIM card or secondary APN of the SIM card, when the data limit of default APN

is exceeded.

Parameter Switch to primary SIM card after timeout defines conditions, how to switch

back to the default SIM card or default APN.

Parameter Switch to backup SIM card when binary input is active enables switching

to secondary SIM card or secondary APN of the SIM card, when binary input ‘bin0’ is active.

Parameter Switch to primary SIM card after timeout enable defines the method, how

the router will try to switch back to default SIM card or default APN.

The following parameters define the time after which the router attempts to go back

to the default SIM card or APN. The first attempt to switch back to the primary SIM card or

APN shall be made for the time defined in the parameter Initial Timeout, range of this

parameter is from 1 to 10000 minutes. In an unsuccessful attempt to switch to default SIM

card, the router on the second attempt to try for the time defined in the parameter

Subsequent Timeout, range is from 1 to 10000 minutes. Any further attempt to switch back to

the primary SIM card or APN shall be made in time computed as the sum of the previous

time trial and time defined in the parameter Additive constants range is 1-10000 minutes.

Example: If parameter Switch to primary SIM card after timeout is checked and

parameters are set as follows Initial Timeout – 60min. Subsequent Timeout 30min

a Subsequent Timeout - 20min.The first attempt to switch the primary SIM card or APN shall

be carried out after 60 minutes. Switched to a failed second attempt made after 30 minutes.

Third after 50 minutes (30 +20). Fourth after 70 minutes (30 +20 +20).

Parameter Initial Timeout sets the time after which the Router tries to make connection

with default APN, range of this parameter is from 1 to 10000 minutes. Parameter Subsequent

Timeout sets the time period for every other next attempt to make connection with default

APN, range is from 1 to 10000 minutes. Parameter Additive Constant sets the amount of time

which is added to every attempt at main connection establishment after unsuccessful defined

attempt (for example: Additive Constant is 15 minutes. After a second unsuccessful attempt at

main connection establishment time of next attempt is extended by about 30 minutes etc.).

Range is from 1 to 1000 minutes.

In the bottom part of the window it is possible to define access over CSD connection

by Enable Dial-In Access function. Access can be secured by used the Username

and Password. When the router is in offline mode, the router is permanently available via

CSD connection.

LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. 09127/59 460-10 * Fax. 09127/59 460-20 * www.lucom.de

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 100 101

Kommentare zu diesen Handbüchern

Keine Kommentare

Vega LUCOM EDGE router ER75i v2 SL USER’S GUIDE Bedienungsanleitung Seite 46

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kommunikationszubehör Vega LUCOM EDGE router ER75i v2 SL USER’S GUIDE