Vega D81 METEC Hydrostatic pressure transmitter Bedienungsanleitung PDF herunterladen (Seite 34)

34 Pressure transmitter D81 METEC

• Confirm the adjustment with "

OKOK

" and after

saving, you are again in the initial menu.

Setup

Note:

If you connect the adjustment software (VVO)

to a sensor from which data has already

been saved, you are asked if the saved data

should be transferred to the sensor or if you

want to transfer the sensor data to the data-

base of VVO (the available data of the cur-

rent sensor will be overwritten).

If you don’t get communication with the sen-

sor, check the following:

- Is the sensor being supplied with sufficient

voltage (min. 12 V)?

- When VEGACONNECT 2 is connected to

the signal cable, is the load resistance

250 … 350 Ω?

Configuration

• Choose the menu "

Configuration/Measuring

system

", to get further information on the

sensor type, the software version of the

sensor, measuring unit, the measurement

loop designation etc.

• Click to "

QuitQuit

Quit

• Click to the menu "

Configuration/Measure-Configuration/Measure-

Configuration/Measure-

ment loop/Modifyment loop/Modify

ment loop/Modify

". This is the first step of

sensor setup.

In the menu "

Modify meas. loop configuration

you can give a name (e.g. vessel 10) and a

description (e.g. cleaning detergent). to the

measurement loop in place of the sensor

number. This will make your entire measuring

system more understandable.

• Now enter in this menu whether a level, a

distance or a gauge should be measured.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Vega D81 METEC Hydrostatic pressure transmitter Bedienungsanleitung Seite 34

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Vega D81 METEC Hydrostatic pressure transmitter