Vega VEGABAR 52 Profibus PA Bedienungsanleitung PDF herunterladen (Seite 26)

6 Set up with the display and adjustment module PLICSCOM

VEGABAR 52 • Probus PA

36719-EN-130321

6 Set up with the display and adjustment

module PLICSCOM

6.1 Short description

The display and adjustment module is used for measured value

display, adjustment and diagnosis. It can be mounted in the following

housing versions and instruments:

•

All sensors of the plics

instrument family, in the single as well as

in the double chamber housing (optionally in the electronics or

connection compartment)

•

External display and adjustment unit VEGADIS 61

From a hardware version …- 01 or higher of the display and adjust-

ment module resp. …- 03 or higher of the corresponding sensor elec-

tronics, an integrated backlight can be switched on via the adjustment

menu. The hardware version is stated on the type label of the display

and adjustment module or the sensor electronics.

Note:

You can nd detailed information on the adjustment in the operating

instructions manual "Display and adjustment module".

6.2 Insert display and adjustment module

The display and adjustment module can be inserted into the sensor

and removed again at any time. It is not necessary to interrupt the

power supply.

Proceed as follows:

1. Unscrew the housing cover

2. Place the display and adjustment module in the desired position

on the electronics (you can choose any one of four dierent posi-

tions - each displaced by 90°)

3. Press the display and adjustment module onto the electronics

and turn it to the right until it snaps in.

4. Screw housing cover with inspection window tightly back on

Removal is carried out in reverse order.

The display and adjustment module is powered by the sensor, an ad-

ditional connection is not necessary.

Function/Conguration

Mount/Dismount display

and adjustment module

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 67 68

Keine Kommentare

Vega VEGABAR 52 Profibus PA Bedienungsanleitung Seite 26