Vega VEGABAR 61 Proﬁbus PA Bedienungsanleitung PDF herunterladen (Seite 20)

2 Remove the housing socket from the mounting plate

Fig. 7: Components of the

external housing for plics

devices

1 Screws

2 Wall mounting plate

3 Cable gland

3 Loop the connection cable through the cable entry on the housing

base

Information:

The

cable gland can be mounted in three positions each displaced by

90°. Simply exchange the cable gland against the blind plug in the

suitable thread opening.

4 Connect the wire ends as described under "Single/Double

chamber housing" according to the numbering

5 Connect the screen to the internal ground terminal, connect the

outer ground terminal above on the housing to potential equal-

isation

6 Tighten the compression nut of the cable entry. The seal ring must

completely encircle the cable

7 Attach the mounting plate again and t ighten the screws

The electrical connection of the sensor to the external housing is

hence ready.

The connection cable is already preconfectioned. If necessary, shorten it to

the requested length, cut the breather capillaries clean. Remove approx.

5 cm of the cable mantle, strip approx. 1 cm insulation from the ends of the

individual wires. After shortening the cable, fasten the type plate with sup-

port back onto the cable.

20 VEGABAR 61 • Proﬁbus PA

5 Connecting to power supply

28251-EN-081209

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 83 84

Keine Kommentare

Vega VEGABAR 61 Proﬁbus PA Bedienungsanleitung Seite 20