Vega Phoenix PSI Data Fax Modem Bedienungsanleitung Seite 64
- Seite / 128
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
PSI-DATA/FAX-MODEM/RS232
4-18 692302
Echo If the echo is on, all characters sent by the PC in command mode are sent back by
the modem. The characters can thus be displayed on-screen on the PC.
DCD Signal When the partner carrier detect signal is detected, the RS-232 interface activates
the DCD signal (Data Carrier Detect). Alternatively, this signal can also be
permanently switched on.
DSR Signal The DSR signal (Data Set Ready) of the RS-232 interface can be permanently
switched on or switched off in command mode.
DTR Signal Your modem can process the DTR signal (Data Terminal Ready) as follows:
– The modem returns to command mode if there is no DTR signal at the RS-232
interface.
– The modem hangs up and returns to command mode if there is no DTR signal
at the RS-232 interface.
– The modem hangs up, is reset, and returns to command mode if there is no
DTR signal at the RS-232 interface.
– The modem ignores the DTR signal. This may be necessary when using a
PLC, as the RS-232 interface of a PLC is often unable to provide a DTR signal.
Flow Control The data flow control of the RS-232 interface can be set for various operating
modes:
– For the "Hardware" setting, the CTS and RTS signals are used for a
bidirectional data flow control.
– For the "Software" setting, the data flow control is bidirectional using XON and
XOFF characters.
– In "XON/XOFF Unidirect" mode, the XON character is sent to the PC (DTE) to
start data transmission and the XOFF character is sent to stop data
transmission. The PSI-DATA/FAX-MODEM/RS232 ignores XON and XOFF
characters sent by the PC.
– Data flow control can also be switched off completely. This may be necessary
when protocols such as 3964R are transmitted, which control the flow
independently.
Compression Data compression on the telecommunications cable results in increased data
throughput.
Modulation Method You can specify the transmission method of your modem (default: CCITT).
Table 6-1 on page 6-28 shows how the various settings work.
- User Manual 1
- 692302 iii 9
- Table of Contents 10
- Section 1 11
- PSI-DATA/FAX-MODEM/RS232 12
- 1-2 692302 12
- 1.1 Description 13
- 1.2 Application 14
- Order No 15
- 1.4 Technical Data 16
- 1.4.3 PSTN Port (a/b Line) 17
- 1.4.6 General Data 19
- 1.5 CE Conformity 20
- Section 2 21
- 2-2 692302 22
- 2.1 Hardware Installation 23
- 6 9 2 3 A 0 3 1 24
- 2.1.3 RS-232 Interface 25
- 6 9 2 3 A 0 3 7 26
- 6 9 2 3 A 0 3 8 27
- 2 4 V 0 V 27
- 2.2 Software Installation 28
- 2.2.2 Driver Installation 29
- 2-10 692302 30
- 692302 2-11 31
- 2-12 692302 32
- Section 3 33
- 3-2 692302 34
- 3 Hardware Installation 35
- 6 9 2 3 A 0 3 2 37
- 3.2.3 LEDs 38
- 3.2.4 Pushbutton 38
- 6 9 2 3 A 0 3 3 39
- 3.3 Electrical Connections 40
- 3.3.1 Block Diagram 41
- 3.3.2 RS-232 Interface 42
- 692302 3-11 43
- 3-14 692302 46
- Section 4 47
- 4-2 692302 48
- 4 Software Installation 49
- 4.1.1 Driver Installation 50
- Software Installation 51
- 4.2 Configuration Software 53
- 692302 4-9 55
- 4.2.2 Operation 56
- 692302 4-11 57
- 692302 4-13 59
- 692302 4-15 61
- 692302 4-17 63
- 692302 4-19 65
- 692302 4-21 67
- 4-24 692302 70
- Section 5 71
- 5-2 692302 72
- 5 Special Functions 73
- 5.2 Alarm Inputs and Alarms 74
- 692302 5-5 75
- 5.3 Password Protection 77
- 5.4.1 Caller ID Output 79
- 5.5 DTMF 80
- 5.5.2 DTMF Control 81
- 5.6 ASCII to Fax Conversion 82
- 692302 5-13 83
- 5.7.1 Sending SMS Messages 84
- 5.7.2 Receiving SMS Messages 84
- 692302 5-15 85
- 5.8 Setting a Partner Output 87
- 5-18 692302 88
- Section 6 89
- 6-2 692302 90
- 6 AT Commands 91
- 6.1 Command Descriptions 92
- 692302 6-5 93
- 692302 6-7 95
- 692302 6-9 97
- 692302 6-11 99
- 692302 6-13 101
- 692302 6-15 103
- 692302 6-17 105
- 692302 6-19 107
- 6.4 S Registers 109
- 692302 6-23 111
- 692302 6-25 113
- 692302 6-27 115
- 6.5 Bell/CCITT Mode 116
- 6.6 Modem Confirmations 117
- 692302 6-31 119
- Section 7 121
- 7-2 692302 122
- 7 Configuration Help 123
- Siemens S7 300/400 125
- 5050df17 128
Verwandte Produkte und Handbücher für Kommunikationszubehör Vega Phoenix PSI Data Fax Modem
Kommunikationszubehör Vega KLD2-GT-DP.1PA Gateway for PROFIBUS DP-PA segment Bedienungsanleitung
(3 Seiten)
(3 Seiten)
Kommunikationszubehör Vega KLD2-PL-Ex1.PA Power-Link for PROFIBUS DP-PA segme Bedienungsanleitung
(3 Seiten)
(3 Seiten)
Kommunikationszubehör Vega KLD2-PL(2)-1.PA PROFIBUS-PA Power Link Module Bedienungsanleitung
(3 Seiten)
(3 Seiten)
Kommunikationszubehör Vega KFD2-BR-1.PA.93 Segment coupler for PROFIBUS PA Bedienungsanleitung
(3 Seiten)
(3 Seiten)
Kommunikationszubehör Vega Creative Modem Blaster V.92 External DE5721 Bedienungsanleitung
(59 Seiten)
(59 Seiten)
Kommunikationszubehör Vega KLD2-PL(2)-1.PA PROFIBUS-PA Power Link Module Bedienungsanleitung
(2 Seiten)
(2 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.399 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern