Vega Phoenix PSI Data Fax Modem Bedienungsanleitung PDF herunterladen (Seite 98)

PSI-DATA/FAX-MODEM/RS232

6-10 692302

Y Break Signal

Z Reset

Use the Z command to reset your modem. Your modem then hangs up and loads

configuration profile 0 or 1. This command must be the last one in the command

line.

&C Carrier Detect Signal

&D Data Terminal (PC) Ready Signal (DTR)

&E Automatic Speed Adjustment (Fall Forward/Fall Backward)

This feature automatically adjusts the speed if the transmission quality deteriorates

while connected.

&F Factory Configuration

The &F command (default) restores the factory settings with V.42bis and enables

hardware flow control.

Y0 No transmission of break signals and no response to them.

Y1 Response to break signals. The device sends a break signal for four

seconds before disconnecting. In addition, it aborts an active connection

when it receives a break signal for 1.6 seconds from the partner.

Z0 Reset and activate stored configuration profile 0.

Z1 Reset and activate stored configuration profile 1.

&C0 Continuous activation of the carrier detect signal for your modem.

&C1 Set the RS-232-C carrier detect signal for your modem (DCD) when the

modem detects a carrier detect signal from the partner (default).

&D0 Ignore the status of the DTR signal. The DTR signal is always activated,

even when your PC is switched off.

&D1 Reset to command mode if the modem detects a falling edge on the DTR

line.

&D2 Hang up and reset to command mode if the modem detects a falling edge

on the DTR line.

&D3 Hang up, reset, and switch back to command mode if the modem detects

a falling edge on the DTR line.

&E0 Disable automatic speed adjustment (default).

&E1 Enable automatic speed adjustment.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 127 128

Keine Kommentare

Vega Phoenix PSI Data Fax Modem Bedienungsanleitung Seite 98